MaxTech NX-16 Guida Utente

Part #MAN108 Rev. 1.0 NX32PCI/DNX-32PCIUSER'S GUIDEHigh Performance32-Bit PCI BusEthernet AdapterWith support for BNC andRJ45 connectors

932-bit (PCI) adapter can only function with 32-bitversions of the EMM386.EXE memory managerprogram (version 4.49 or later). You can verify itsversion

10tion for the adapter. Click “OK” to install the adapter.Windows 95 may request its own installation disksfor some files. Insert the Windows 95 disks

11Section Five - TroubleshootingThis section describes some of the common prob-lems you may encounter while using your networkadapter. When troublesho

12nators. If the terminators do not measure 50 ohms+/- 1%, replace the terminator. Measure the coaxialcable with a 50-ohm terminator attached to oneen

13IRQ: BIOS/Operating System selectable.Interrupt: INT ARAM Buffer: 16 KBPower Consumption: 2.5 WTemperature: 0 to 50 degrees C (Operating)-20 to +70

14from the date of purchase. During the warranty period,MaxTech will repair (or at its option, replace) the product thatproves to be defective, provid

15lation. This equipment generates, uses and can radiate radiofrequency energy, and if not installed and used in accordancewith the instructions, may

1Section One - IntroductionMaxTech’s NX-32PCI Series network adapters arehigh performance, full duplex 32-bit adapters con-forming to IEEE 802.3 stand

22.1 Unpacking Your Network AdapterYour package should contain the following items:Adapter Card BNC T-connectorDriver disk User's GuideThe back p

31. Turn off your computer and all peripherals.2. Make a note of the power cord and othercables connected to your computer anddisconnect them.3. Remov

4turn to Section 2.2 to continue installa-tion.2.3 PCI Adapter ConfigurationThe steps used to configure your adapter dependon whether your computer sy

5the IRQ.The procedures to perform PCI card setup on earlygeneration PCI bus PCs and the related terms todescribe each procedure vary depending on whi

6information.To run SETUP.EXE, insert the driver diskette intoa disk drive.From the DOS prompt, change to that drive bytyping A: (or B:) and pressing

7The Full-Duplex Function should be enabled onlyif the server you are attached to and all intercon-necting devices (e.g. switching hubs) support thism

85. RAM Test: Checks on-board RAM.The Run Diagnostics on Network option allowsthe user to test the network cable connectionbetween two cards. One card